The original is awesome -- I just didn't mind putting holes into the drywall with drywall screws (my kids are young and like to be rude to some of this wall mounted stuff).
This remix is the same, but, adds countersunk holes for your typical drywall screw. I've also removed the previous holes on the back that were there for 3M strip adaptation (see the original for the 3M style, it's pretty smart!)
Printer Brand:
Bambulabs
Printer:
Bambu P1S
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
15%
Filament:Bambulabs PLA Orange / Green
Notes:
The supports are minimal. Refer to the original creation this is remixed from for instructions, as there's a small 1 inch area that is mildly tricky. Not too bad though.
Remix was created in Blender.
Category: Organization