Eryone Cardboard Adapter V12

Eryone Cardboard Adapter V12

Boost
13
35
25

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
36 min
1 plate
5.0(22)

Boost
13
35
25
1
123
238
Released

Description

Nun ja.. ein anderer Spulen Adapter für diie Eryone Papp Rollen. Da die meisten leider nicht wirklich passen und im Ams ständig von der Spule fallen, hab ich kurz mal die Rolle durchgemessen und in Fusion360, diesmal mit Rast Nasen konstruiert, damit die Teile da bleiben, wo sie sein sollten. Wer will kann gerne die Daten dazu benutzen, um sich die etwas stylisch zu kreieren.

 

-english translated by Ggl (..not mine :) )

Well... another spool adapter for the Eryone cardboard rolls. Since most of them unfortunately don't really fit and keep falling off the spool in the Ams, I quickly measured the roll and designed it in Fusion360, this time with locking tabs so that the parts stay where they should be. If you want, you can use the data to create something stylish

Comment & Rating (25)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
Works as described. I printed them in PETG. since the cardboard spool vary I had to print another one with 101,5 scale for it to fit.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Snaps perfectly to the spool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt super, besser als andere Drucke, die man hier findet. Danke! Better fit than other prints I found here. Thanks!
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This Cardboard adapter fits great. Took about 32 minutes to print and feels solid on the spool.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I tried the others but this ring is the winner by a long shot
0
Reply
Keine Ahnung mit welchen Modell das getestet wird, aber so klappt das nicht. Soweit ich gelesen habe sind die 2014 geändert worden. Man bekommt die unmöglich über die dummen Stifte drüber. Weis nicht wie das gedacht wurde aber so nicht.
0
Reply
OUTSTANDING Ring, i myself have ran into one ring after another not fitting properly, falling off, or just plane not working unless you glued it on the cardboard. THIS ring fit perfect , lookd good and works as advertised. i was so pleased with it I went to follow this poster to see if they had more rings for other brands and was bummed that there were no others. Outstanding job my friend and all i can say is if you make more of these to fit other brands you will gather one heck of a following thanks again ten stars deserved
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
5*
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This design has been very helpful as I pretty much only print with Eryone Filament. I have printed it out several times and I have yet to have a problem with it.
0
Reply