IKEA Trofast Box Adapter for Kallax
Copyright Claim
IKEA Trofast Box Adapter for Kallax
Boost
47
134
12
Print Profile(1)
0.2mm layer, 4 walls, 20% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
47
134
12
4
81
75
Released
Description
A simple adapter to be able to use the Trofast boxes in a Kallax shelf.
Printed it with PLA. PLA was also used for the support. This was very easy to remove from the print.
I fastened them with so-called “Euroschrauben” (6,3 x 13 mm). Due to the thin furniture material, I pre-drilled with a 4 mm drill bit.
Comment & Rating (12)
All
Boosted
Almost perfect!
It was a bit hard for me to position them even, so something like a small distance stick, than can be stick between them etc. would be ideal.
Also I reduced the infill to 15%, i think at the parts where is infill, it does not matter so much, but saves a bit of filament.
Anyway it feels stable, and works nicely.
The designer has replied
1
Reply
Thanks! Thats a good idea. I will Update the model with distance sticks.
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
perfect! and great idea! since I was struggling with cardboard boxes in my kallax...
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 20% infill
almost perfect, just something like distance sticks to attach it even would be great.
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 20% infill
worked fine for me
The designer has replied
1
Reply
I am glad to hear that! Thank you for your feedback!
0
Reply
Boosted
Thank you very much. That worked absolutely fine.
1
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
Works fine
1
Reply
Where could I get the information on the distances at which to place each rail?
I would like to avoid leaving them too close or too far apart.
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld