Hex Light Diffuser
Print Profile(2)
Description
My first upload so go easy on me! :)
I bought one of those hex light kits from Amazon. These are usually installed in a garage, but I wanted them in my maker space. After installation, I discovered they were WAY too bright and not dimmable. So I designed and printed these covers, and the work perfectly. I just used white, but they can be printed in any color depending on the look you're going for. There are flexible enough to just snap onto the light.
PLA at 28mm layer height is perfectly fine for these. Each section is 185mm which covered half of light section. You will need two per “side” so 12 total to do an entire hexagon light. Make sure to measure your lights and scale the model accordingly.
Boost Me (for free)
Feel free to boost if you find my print useful!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)