Cover for installation on double-sided tape.
Cable channel with a diameter of 6 mm (the cable moves freely when pressed), the edges of the cover are 1 mm lower than the structure in order to be pressed more tightly to the floor.
I chose cover length 100mm, because printed vertically with brim at slow speed.
You can change the cover length using an f3d file.
UPD
I added another option with a forced brim, because in my case the brim from orca slicer or bambu studio is a very bad helper. This option was able to print with a height of 150mm in vertical mode without any problems.
UPD
The previous version, despite the raft, came off the table 50/50. Added the final version with a durable raft (minimizes the chance of the model coming off the table) and geometry optimized for the slicer.