Low Profile PhaseworksCA Art Display
Remixed by
Low Profile PhaseworksCA Art Display
Remixed by
Boost
15
12
4
Print Profile(3)
Three shelves - 0.16mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Single Shelf - 0.16mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Two shelves - 0.16mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
15
12
4
0
34
18
Released
Description
This display shelf is designed to be used with double sided adhesive tape.
The one picture shows two 320mm shelves side by side to make one 640mm shelf. the shelf pictured has a 14mm lip for attaching tape.
The slot is 4.2mm to be compatible with most of my line art uploads, which have a thickness of 4mm.
It is not necessary to put tape along the entire length, since the art pieces are very light. I just used a short 3cm piece of tape at either end of each section and that was more than sufficient!
Comment & Rating (4)
All
Print Profile
Three shelves - 0.16mm layer, 2 walls, 15% infill
fits most any <4mm piece including hueforge, pretty quick print. supports some heavier prints. could be used as a set of french cleats.
0
Reply
Print Profile
Two shelves - 0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Single Shelf - 0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Three shelves - 0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld