.410 Ammo Case - 6 Rounds

.410 Ammo Case - 6 Rounds

Boost
6
5
3

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Case, Tray, Lid on 1 build plate
Case, Tray, Lid on 1 build plate
Designer
1.5 h
1 plate
5.0(1)

Open in Bambu Studio
Boost
6
5
3
0
12
6
Released

Description

.410 Sliding Lid Ammo Case. Holds 6 rounds.

 

Fits 3in (76mm) / 2.5in (64mm) / 2in (51mm)

 

I'm sorry that I cant make a case that will fit everyones shotgun shells exact. Unlike bullets, shotgun shells are measured (and then labeled) by their approximate length once fired. Because of this its hard to make/design a case that fits the exact length of a shell. For example, a shell labeled 2.5" (64mm) length can actually be 2.3" (58mm) before firing. On top of this, different manufacturers actual shell lengths will vary based on how tightly the shell is crimped, and the thickness of the shell. Thanks for understanding.

 

If the tray doesn't fit snug: Place a drop of superglue on each post and then press the tray onto the posts. Let the glue fully dry and before placing ammo inside, or before sliding the lid on. This is to prevent any superglue residue or “bloom” from getting on your ammo and lid.

 

When printing the tray that you stick the rounds into you may have to adjust the X-Y hole compensation in your slicer, depending on how well your printer is calibrated.

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Will 45 Long colt fit It should right?
The designer has replied
1
Reply
To be honest, Im not sure. But I don't think so. I believe the 45 long colt has about a 1.5mm wider diameter but I could be wrong.
1
Reply
Print Profile
Case, Tray, Lid on 1 build plate
0
Reply
No more