Challenge Coin Holder Pyramid Display Stand

Change Note (11 May 2025): I have since added 2 size test print profiles and the full size coin holder profile:

• Full size is for the A1 or bigger printers and is the actual correctly designed size. That doesn't mean it will fit every coin out there! Some are quite big. That is what the next two profiles are for.
• CoinTestFit-f-FullSize- This is a cut of the side profile laying flat. If you print this, you can hold it up and see if your coins will fit in the coin cut-outs. This can save you from printing the whole thing just to find out your coins may not fit!
• CoinTestFit-f-82p- This is the same cutout as above but is just the 82p (A1Mini) size model. If you have smaller coins you can probably stick with this one as most of my coins fit into this one too.

---

This is a pyramid-style display stand/rack for challenge coins. The bottom “shelf” for coins is bigger at about 6.4mm while the other “shelves” are only 4mm. The inside or internal structure has been cut away to minimize the need for infill and time.

It was admittedly designed for my bigger printer with a bigger bed… But I only have the A1M right now, so I slightly redesigned it and made it a bit smaller to print on the A1M bed. 

If you choose not to use my own print profile, I at least still recommend adding a brim to each corner of the print to prevent "elephant foot".

Note: I marked it as non-commercial so please get in touch with me if you would like to sell it.