Bosch 18V Battery Holder ✕ IKEA Skadis
Remixed by
Copyright Claim
Bosch 18V Battery Holder ✕ IKEA Skadis
Remixed by
Boost
4
18
6
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
4
18
6
0
26
27
Released
Description
This design is a customized version of the wall mount for Bosch 18V batteries, tailored specifically to integrate seamlessly with IKEA Skadis boards. Note: The hooks require support structures. Print with 3+ perimeters and 20% gyroid infill. PETG recommended, but PLA should work as well.
You can find the two slot variant of this holder here.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
a little too snug on the battery, I lift the whole thing off the board while trying to remove the battery
The designer has replied
0
Reply
Ensure the secure placement of your accessory with the Skadis Lock Plug, available here: https://makerworld.com/en/models/92747#profileId-99258
Moreover, allowing it a few cycles without being attached should noticeably ease the process.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
ist etwas zu groß. kann man das einfach runterschlucken?
The designer has replied
0
Reply
runterschlucken? Meinst du skalieren?
Du kannst in Bambu Studio skalieren, musst nur drauf achten, dass du nicht das Gesamtobjekt, sondern nur den Teil namens "Holder" skalierst. Außerdem achte beim Skalieren drauf, dass du zu den Haken hin skalierst, sonst sind die Haken ggf. nicht mehr mit dem Holder verbunden.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld