Hydrometer chamber holder
Copyright Claim
Hydrometer chamber holder
Boost
20
35
12
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
48 min
1 plate
Open in Bambu Studio
Boost
20
35
12
0
83
46
Released
Description
Test model for hydrometer with AA battery power mode, snaps in place behind toolhead next to poop waste
Comment & Rating (12)
All
How can I make it fit into the P1S chamber? It seems those little nobs on the underside of the pins make it not fit into the wholes. why are they there? are tho wholes different in the x1c chamber? added a picture how they look for me and the have no opening where the small knop could fit in
its a very nice model
(Edited)
The designer has replied
0
Reply
you can cut off with slicer and use double sticky tape as well.
0
Reply
Replying to @Alex.Vikingo
ah, but that means these wholes do look differently in the X1C?
0
Reply
Replying to @teconomix
yes, I found out, some models of X1C have different. no sure, I share step file, but when I get to my pc I will upload it for easy edit
0
Reply
Fits perfectly with clearance from the belts and tool head.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
very nice model. I had to cut out the little bridges next to the knoby on the bottom to make it fit the p1s. but else it is very nice and fits the hydrometer perfectly.
however, it's a bit difficult to see the temp in the video feed.
I used petg for the body and play for the logo
(Edited)
0
Reply
The print profile is no longer public
print was good fit perfectly
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
sehr schöne Idee aber man sieht sie im Bauraum kaum
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld