UEFA European Football Championship Trophy
Copyright Claim
UEFA European Football Championship Trophy
Boost
50
67
52
Print Profile(1)
0.16mm layer, 2 walls, 20% infill
Designer
4.1 h
2 plates
Open in Bambu Studio
Boost
50
67
52
18
330
201
Released
Description
This is a replica of a existing trophy that is won after the UEFA European Championship.
(If it happens that the connection between the top and bottom part is too loose, use few drops of superglue)
Comment & Rating (52)
All
Boosted
🤗🙏🏻
The designer has replied
1
Reply
Very shiny :D! What filament did you use?
1
Reply
Boosted
This is esun, silk PLA, metal silver
0
Reply
Really LOVELY !!! Only Issue: The Fans in your settings where all at 100% .. 6h Noisyness
The designer has replied
1
Reply
nice print. What filament is that if you don't mind me asking . has a nice shine to it ! How did the underside of the handles come out without supports?
1
Reply
Thank you very much. I didn't notice the sound because my printer is located in my basement.
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 20% infill
good quality and easy to modify
The designer has replied
1
Reply
Thank you! Nice addition of the text :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
Looks great. Thank you. I love it 😎👍
(Edited)
The designer has replied
1
Reply
Thank you! Looks clean ;)
0
Reply
Boosted
Loved this still a little work to do smoothing and removing the seam but a great model.
The designer has replied
1
Reply
Looks very smooth! Thank you for your feedback! :)
1
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
Very nice. wish the seams weren't in through the text but I'll fix that in thr slicer and reprint it. awesome print.
The designer has replied
1
Reply
I didn't notice the seam placement when I was making that profile. Will change that, thank you for you feedback! :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
Looks perfect and prints flawless
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
awesome print
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
scaled it so the whole model has a height of around 60cm, looks great
The designer has replied
1
Reply
Sound good! Would you mind sharing a pic? I'm interested in the looks of it scaled up. 😁
0
Reply
sure
(Edited)
1
Reply
Replying to @AlienElement
Looks great! I was thinking about printing it large as well and then trying to give it a shiny paintjob :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
(Edited)
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld