Bambu Lab cover backhole long
Copyright Claim
Bambu Lab cover backhole long
Boost
42
74
13
Print Profile(1)
0.2mm layer, 2 walls, 35% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
42
74
13
0
99
63
Released
Description
Deutsch:
Mit der Abdeckung verschließt man die hinteren Löcher und den Schlitz zur Rückwand. Ich habe an den äußeren Enden ein Stück doppleseitiges Klebeband befestigt.
Ich habe eine Bambu Lab X1C, ob das auch bei einem P1P funktioniert, kann ich leider nicht sagen.
Englisch:
The cover closes the rear holes and the slot to the back wall. I attached a piece of double-sided tape to the outer ends.
I have a Bambu Lab X1C, but unfortunately I can't say whether this also works with a P1P.
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 35% infill
Not so good measured. The print don't fit well.
Printed for X1C.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
With these settings it didn't fit my X1C with the filter in it and it didn't lay flat. I had to cut the part to use it.
The designer has replied
0
Reply
I also have an X1C and it worked for me. Do you have a photo of it?
0
Reply
It wouldn’t show now because I already cut it. Sorry about that I may print it again to show you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
Simple yet elegant. Needed to clean up the look inside the printer. Worth the print for sure.
0
Reply
Mit doppelseitigem klebe Tape passt. Halt passend gemacht ;-) Hab einen X1-Carbon :-)
0
Reply
0.2mm Layer, 2.5.3 Walls, 35% Infill. Fited not like a charm, But with double sided tape it made it ;-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 35% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld