QIDI X-MAX Side Spool Holder
Copyright Claim
QIDI X-MAX Side Spool Holder
Boost
4
2
5
Print Profile(1)
0.2mm layer, 6 walls, 10% infill
Designer
4.6 h
2 plates
Boost
4
2
5
2
12
5
Released
Description
This is a spool holder for the side of the machine. The fixing posture is in the cavity of the filament sensor, and the sensor will be fixed on the spool holder!
You have to change the PTFE tube for one 120mm longer than the original, the cable for the sensor will be on the full length if it bothers you you can extend the cable by cutting the cable and soldering an extension, but mine worked out ok!
Comment & Rating (5)
All
Boosted
Print Profile
0.2mm layer, 6 walls, 10% infill
The designer has replied
0
Reply
TOP :D
0
Reply
Boosted
how did you get the run out sensor cable to stretch all the way? prints came out perfect btw.
(Edited)The designer has replied
0
Reply
open the dor and give a litle push on the ziptie !
0
Reply
yes ! i have opened the back dor and cutet the plastic strip that is holding the cables an the cable was good !
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld