Bonsai Tree No.2

Bonsai Series – No.2

Growing on a rock Bonsai style (Seki-joju)

Notes

• This is the 2nd model in my Bonsai series.
• The default print profile has a diameter of approximately 73mm width 140mm height 
• I’ve split the model into two parts and added a connector to join them.
  • so there will be a little visible seam between 2 parts
  • However, I will also provide an uncut version in the print profile for those who want to customize it
  • I intentionally left some support structures on the base model to create the effect of tree roots passing through the rock and reaching the ground—giving it a more natural and dynamic look!

Recommendations

• The trunk needs to be printed at a 45-degree angle; otherwise, removing the support structures would be extremely difficult.
• Use pliers for removing supports.
• Use small plastic model cutters to trim the supports into smaller sections instead of pulling them off directly—since the branches are quite delicate and may break.

If you like this model, be sure to check out my other designs!

Link

Powered by Image-to-3D from MakerWorld (https://makerworld.com/makerlab/imageTo3d)

P.S. For my third model, I might experiment with separate parts that allow printing in different colors for each section. Stay tuned!