Ultimate Karak & Carcassonne tile grid holder
Copyright Claim
Ultimate Karak & Carcassonne tile grid holder
Boost
36
89
34
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
36
89
34
9
112
236
Released
Description
Catacombs of Karak is a great game full of emotions. Sometimes these emotions turn into dangerous movements and can distort cards on the table. This 4x4 grid helps with that.
And oh yeah, its stackable and connectable too!
You can use it with Karak or Carcassonne.
.
I used PLA, but pretty much any 3D material will do just fine as long as it doesnt warp.
After printing, just cut off the small brim between the connections (see final look of the part in the photos) and enjoy.
I also included a 3x3 version for smaller printers such as Prusa mini or A1 mini.
Comment & Rating (34)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
Looking real good but needs to be a bit light in my opinion
1
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
Very nice!
1
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
impression sans difficulté
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Ich habe es direkt 16 mal gedruckt und es passte aus der App perfekt.
Ich hätte es gerne schneller gedruckt, habe es aber mit 100% gedruckt um zu prüfen ob es past. Ins habe ich in Weiss gedruckt, dass ist nicht so gut oder es kommt auf den Tisch an.
Mega gutes teil.
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Prints great, works great. thanks.
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Didn’t take a picture but they look exactly how they do in the thumbnail above. Also love the studs along the top to align them when storing!
The designer has replied
1
Reply
Thank you for the review! :)
0
Reply
Boosted
Simple and very nice 👍
The designer has replied
1
Reply
Thank you!
0
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
Just perfect! Thank you!
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Great print fits nice together.
Even a special design to stick the print to the plate without brim.
(Edited)The designer has replied
1
Reply
The thin section is there only for printing. You are supposed to cut it off. See the model details, and please correct the rating.
0
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
broke the frame at the thin section where the tab from another frame should nest when taking the part of the buildplate. might be good to add some more material to improve strength…
(Edited)The designer has replied
1
Reply
The thin section is there only for printing. You are supposed to cut it off. See the model details, and please correct the rating.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld