Simple Tab Dispenser for Dishwasher
Copyright Claim
Simple Tab Dispenser for Dishwasher
Boost
114
209
13
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
14.7 h
1 plate
0.2mm layer, 3 walls, 2% infillfor faster printing
Designer
10.1 h
1 plate
Open in Bambu Studio
Boost
114
209
13
0
146
55
Released
Description
Simple Tab dispenser for the Dishwasher Tabs.
Fill in From the Top, take out at the bottom. Has a slide so the tabs slide down trough gravity.
Support is needed for the design holes, but if its not that important you can also print without support.
Comment & Rating (13)
All
I like this idea for storing diswasher tabs. The cut-outs on the sides are causing problems for my A1 mini. Would you be able to add an extra design that does not have the cut-outs on?
The designer has replied
1
Reply
thank you, and of course, it will be done tonight or tomorrow.
0
Reply
i'll uploaded a model without cutout but since i dont printed it again i have to hope that it will be added
0
Reply
0
Reply
Print Profile
0.2mm layer, 3 walls, 2% infillfor faster printing
Support Issue
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
The designer has replied
0
Reply
thanks :-)
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
Strength Issue:hexa
The designer has replied
0
Reply
Why dont u use the Print without hexa then?
(Edited)0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld