This is a handle to carry trash bags with those annoying thin loops that cut into your hand.

I designed it with the 30L trash bag from Mercadona in mind.

This design allows to carry up to 3 bags in the 3 slots, or 1 bag along the long way. Possibly even 4 if you use both orientations at once.

Many of the other designs had hooks under the grip, which means the bag hangs lower, and it needs more material, but this way, both the handle and bag support is done by the same piece, and it fits into a pocket once done.

The 12cm version is designed for a palm width of 10cm and uses 45g in 1h03m.

The 10cm version in the raw files is designed for a palm width of 8.4cm and uses 38g in 55m.

It was printed with 3 layer walls and 30% infill with matte blue PLA (11600) on an A1.