Handle with cable winder
Remixed by
Copyright Claim
Handle with cable winder
Remixed by
Boost
4
10
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
45 min
1 plate
Open in Bambu Studio
Boost
4
10
2
0
16
9
Released
Description
This is a handle I remixed, it can be used for anything. Fasten with M6 hex-headed bolt, a hex hole is included in the design.
N.B. 100mm refers to mounting hole spacing. Overall dimensions are 116 x 48 x 16mm
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
fantastic. used these for extra window spline. 10/10
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Wonderfull! I scaled it so i used almost all the build plate. I wish there was a handle direct attached so i can hold it properly when i wind the cable.
Other than that it does what its purpose is
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld