Kitchen and Bathroom Sink Splash Guard

Is it just me, or does anyone else with an open kitchen have the same issue where water gets everywhere?! The design looks clean and neat, but it’s not very practical for cooking and washing dishes.

So, I built a splash guard that perfectly solved my issue, with dovetail connections between left and right components. The 3mm/5mm detachable pads (Optional) provide stability and help prevent mould forming underneath the guard.

**** Please do not use for commercial purpose or upload to other platforms ****

!!! Updates 22/02/2025 !!!

If you need a longer slash guard, please check out the following link to Modular version!

!!! Updates 15/02/2025 !!!

Thank you all for the Likes, Comments and Boosts! I would like to share a quick update on the current version after using it for a couple of days. 

1. Increased the nose size to 10mm with a notch underneath to prevent water from escaping to the bottom.

2. Added a 3mm Round Pad in case the the height is too tall and blocks the tap handle.

   

3. Added a full-edged version to prevent water from seeping through the connection to the bottom. 

   

2 Sizes available:

• Size 1: 10.3 cm (excluding dovetail) length Left/Right Splash guard
• Size 2: 19.2 cm (excluding dovetail) length Left/Right Splash guard
• 11 cm width
• 3 cm distance from the edge of tap to sink
• Maximum tap diameter: 4.5 cm
• 4 x 3mm/5mm height detachable feet for each component (Optional)
• Dovetail connection
• 0.4mm tolerance

Non full-edged version:

• May need to apply some bonding between the connections - such as Blue tac, Tape, or Silicone sealant - to prevent water seeping through