This is my redesign of a model that was unable to be printed successfully. I carefully disassembled it and reassembled it with a greater opening of the lid to allow it to be printed without internal supports and work properly.

Please check your slicer to ensure there are supports under each hinge. I personally didn't have this issue but someone did and rated it 4 stars…. the other note was that the support can be difficult to remove from under the left wing. If you aren't careful this can cause it to lose the tip.

Please like and RATE this model! We love seeing your result so please come back and share a photo when you're done!

If you'd like to buy me a coffee to support this and future projects https://www.popsession.co.nz/products/buy-faran3d-a-nuka-cola