Search models, users, collections, and posts
Print Profile(1)
PETG 0.2mm layer, 3 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
68
206
27
15
373
207
Released
Description
since the original cap was way to high for me needs, i made it low profile, but this did not distribute the water well enough, and it tended to splash on one side - so i added this “knob” in the middle, that solved this issue
prints with no supports
Boost Me (for free)
Enjoying my models? Show your support with a Boost! Boosting not only adds a few extra points my way - it also helps cover the material costs that goes into prototyping each design. Every bit of support helps me keep creating fresh, high-quality models for you to enjoy! Thank you for helping keep the creativity flowing 💡✨
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (27)