Turned out great. Really appreciate the time spent modeling this. my kiddo is a happy camper!!
if anyone else is struggling to find the 2mm rod. I used 1.4mm hobby wire from Home Depot and it worked fine.
I had the same problem. Open in windows. Click the triple dot icon top righish of the window. Select rezise image. Use 129x168 pixel for control panel and 192x213 pixel for the badge. Should fit ok and you can play around with size from there. Suggest practice print on paper first. Hope this helps!
for the tv i just printed "fit to page" and trimmed to fit. If you want to try and adjust pixels measure the tv part and use pixel to inch or cm converter online. https://www.omnicalculator.com/conversion/pixels-to-inches
Aww man. Just ordered yellow, red, blue, white and black the day before you uploaded... and already have grey. but no light blue. was going to make tge one from thingiverse. This however looks so much better. Will print!
Hi Martin. having trouble with the roof? any suggestions? Can I see your result of the roof :-/ I have calibrated the filament and the test block I printed looks fine. So cant nail down the problem.
Pretty good. My son likes it. For some parts, like the slide I would recommend to print it different (see my pictures). This safe over 1h print time, less waste and easier to remove the support.
took a while to print, put together, a ton of glue and had a slight later shift on the bottom two pieces (my mistake as sure my ptfe tube was too tight) but came out amazing what a brilliant design my son loves it