A1 Mini NinjaFlex 85A Test Print by ondrovic

ondrovic

3D Printer>Test Models

GIF

Print Profile(3)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Solid - 0.2mm layer, 2 walls, 5% infill

Designer

25 min

1 plate

4.5(2)

Use This Profile - 0.12mm layer, 3 walls, 10% infill

Designer

38 min

1 plate

5.0(1)

Spiral Vase Cube - 0.2mm layer, 1 walls, 0% infill

Designer

20 min

1 plate

Open in Bambu Studio

Boost

Released

Description

Just a quick test model for printing NinjaTek NinjaFlex 85a tpu on the A1 Mini (also makes a good model to flush previous filament) should be able to tweak settings as needed

Not 100% but gives you an idea, used basic settings, haven't tweaked, filament still a little wet

Multiple Models
- Spiral Vase
- Solid
Key Takeaways
- Textured Plate
- External Spool Holder
- Slow printing

Note:

To help release TPU from bed do the following:

let bed cool
spray edges of print with 1:1 ratio IPA/Water

Version History:

2023-12-24 - Uploaded new profile that should work way better

Comment & Rating (5)

@NewtonBusters

Thanks. Just tried this on my X1 Carbon and the profile printed very well. Some splitting of the cube at the top and bottom line surfaces into the side walls (when squeezing the cube), but no issues with the quality. Need to look at the temps and inside-outside overlap to see why there was insufficient layer bonding here. Perhaps doing walls outside-in might help. But overall VERY happy with this profile as it made getting NinjaFlex up and running on my X1C almost plug and play.

(Edited)