Fotorahmen

Remixed by
Copyright Claim

Fotorahmen

Remixed by
Boost
4
8
10

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
7.5 h
9 plates
3.8(4)

Boost
4
8
10
0
35
50
Released

Description

I just added some variants of this beautiful photo frame by wuguigui. Thanks to wuguigui for sharing this model. You can find detailed information in the original model description.

Comment & Rating (10)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
had to use t8ny dab of glue for the peg, I'll upload my profile where I increased the oeg parts scale 110% so it snaps in snug no glue needed. works great with 4x6
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I had a problem sticking to the table. It's probably my fault. The fill rate for the pin remains low.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I had to reduce the model by 0.5%, but otherwise the profile prints well.
The designer has replied
0
Reply
Which one of them?
0
Reply
Replying to @CTeipen :
All of them.
0
Reply
oh and i used a small cut up piece of support (cut into 4ths) for a stand! hot tip of a lighter "solder" or glue it on. that way you can reuse the large support piece that comes off this piece and you can also use a few slices to glue/solder on a lip to prevent photo from sliding
0
Reply
second one looks like 4 x 6 inches lol and seems most efficient frame on makerworld I've found
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
You got some advice for improvements?
0
Reply
Replying to @CTeipen :
just scale up that lil peg or maybe ill upload a profile, like, maybe have a fold outable simple stand thing!
0
Reply
No more

This remix is based on


License

This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike