Top Glass Holder
Copyright Claim
Top Glass Holder
Boost
7
14
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
43 min
1 plate
Open in Bambu Studio
Boost
7
14
6
0
30
26
Released
Description
Slides under the side of the printer and holds to top glass. I used a piece of double sided tape to make sure it stays snug to the sid eof the printer. I like to take the top off when i swap nozzles and didnt like putting it on the floor.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Just works!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
added some ironing, love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
simples gutes Design! Macht was es soll und hält den Glasdeckel perfekt.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld