Update January 25, 2024: A new version of this model has been released! It prints much cleaner at the bottom, and has the same threading. Check it out here.
This is a large threaded egg. It was designed to be large enough to hold one of McGybeer's articulated dragons (printed at the default size). Looks particularly good in multicolor coextruded filaments.
It will print OK without supports, but the bottom points of some of the scales get a bit messy.
Update January 5, 2024: There is a new “revised” version which aims to address some of the issues with the messy early layers. It's not perfect by any means, but it has a wider base which is less prone to issues. There is also improved alignment of the lower scales.
If you would like to print this model for commercial use you must purchase a license here: https://thangs.com/designer/Sprocket%20Studios