showerhead limescale remover
Copyright Claim
showerhead limescale remover
Boost
36
53
14
GIF
Print Profile(2)
without support 0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
with support 0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
36
53
14
0
80
33
Released
Description
avete problemi con il calcare sul soffione della doccia? non temete, in pochissimi secondi sarà rimosso grazie alla saponetta anti calcare!!
do you have problems with limescale on the shower head? don't worry, in just a few seconds it will be removed thanks to the anti-limescale soap bar!!
Comment & Rating (14)
All
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
(Edited)
Support Issue:I have tried printing it twice through the Bambu Handy app but the print would fail quickly. It's because the print profile doesn't include support which is needed for the soap shape. I opened the file in Bambu studio, added some support, and it printed correctly.
The limescale remover works, it's much simpler to use it than scratch everything with my nails.
Thanks for sharing your design, though it would have been nice to provide a working printing profile
The designer has replied
1
Reply
Grazie per il tuo commento, io ne ho stampati diversi, tutti senza supporti e non ho mai avuto una stampa fallita.
Posso aggiungere i supporti al profilo, sicuramente non è una grande perdita di Filamento.
Grazie per averlo stampato, sono sicuro ti troverai bene!
(Edited)1
Reply
Replying to @Pandart3D
I added some organic (tree) support for it to print. I think it uses less filament and it's definitely easier to remove. It might be due to the A1's moving bed.
I would have put 4 stars but then I would not have been able to correctly flag the support issue.
Anyway, thanks for your response and again for sharing your design
0
Reply
Replying to @Xzaninou
ho aggiunto un secondo profilo con i supporti ;)
(Edited)1
Reply
I don't know why my comment is invisible and I can't respond to your question. Yes, there is a very sharp angle at the bottom and the supports are not working corectly. During the printing, I had to watch the bottom and react. Best regards, Piotr
0
Reply
Ok, I already know - it has been removed. I expressed my opinion, which was deleted, because it was unfavorable. So let's pretend that everything is perfect.
0
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
Bottom part really needed some supports, but since it's not the functional part of the print it's fine.
The designer has replied
1
Reply
se guardi bene ci sono 2 profili, uno ha i supporti, se puoi modifica la valutazione per favore e se ti serve stampa l'altro.
0
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
with support 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
without support 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld