be warned the base doesn’t naturally screw into the stand, however I found a creative fix. I just dipped the screw part into boiling water to soften it and it screwed right in! can’t hold controllers on the top stands while there are switch controllers in it but overall good model!

I like the way it prints generally. The same problem everyone else said with the screw in size being too tight. I had to hit mine with a bit of butane torch on both sides to soften it and make it screw in. Shrinking to 98% wasn't enough.

just printed this. the base will not screw into the stand. I had to heat it up to get it to fit enough to hold. maybe adjust your tolerances or add your print profile.

Leider passt die Grundplatte nicht in das gewisse vom Turm rein. Habe es sogar noch mal gedruckt und etwas skaliert aber auch da hat es nicht gepasst. daher leider unbrauchbar.

Pretty cool Idea, but Unfortunately the socket does not fit to the base plate :-/ The socket has no fully functional/identical screw thread as the base plate, please update this. I tried, but failed :-/ EDIT 2024-01-05: heat up the socket on the stand - not the basement - until the socket has a bit of softened plastic - after that, you can put the screw in and you can use it like nothing happened :-)

Good print but need to put the screw part in hot water for it to work properly!

底座螺钉与支柱不匹配，完全拧不进去

Das Gewinde hat erst gepasst,nachdem ich es bearbeitet habe!

Same issue as Breylen, base screw does not match tower socket. Full size doesn't quite fit on an A1 mini plate, but 99% does and fit joycon rails. Will need slight modifications to be perfect but is a fantastic concept.

So cute.