Compact Controller Stand Remixed by Inofaith

Remixed by

Inofaith

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

0.24mm layer, 2 walls, 10% infill

Designer

6.1 h

1 plate

4.8(6)

Lightning infill. Less time, less weight, less stable.

Designer

4.8 h

1 plate

Open in Bambu Studio

Boost

111

Released

Description

Remix of Dadtaxes3D's controller stand.

I noticed that others were having a bit of trouble with the stand and the base not screwing in as they were supposed to. So I took the original main part of the stand and created a new base which was merged with the tower.

For this to turn out ok since it stands vertically, I had to use tree supports for the holes in the model.

I added a print profile with lightning infill. This one takes less time to print, but it's less stable due to its decreased weight. So be careful when adding or removing your controllers.

If you see room for improvement in the model, feel free to leave a comment! :)

Comment & Rating (10)

@zeroxerozero

Boosted

Print Profile

0.24mm layer, 2 walls, 10% infill

printed well with no issues.

@chenry_76

Print Profile

0.24mm layer, 2 walls, 10% infill

The designer has replied

@Inofaith

Glad it turned out good! Any thoughts on what could be improved? :)

@chenry_76

Replying to @Inofaith :

Not that i know of.

(Edited)

@kunee

since you asked about potential improvements, I would appreciate if one of the “controller levers” could go fully straight, at a right angle to the tower. would make holding a pair of headphones more convenient

The designer has replied

@Inofaith

Thank you for the feedback, It's actually not a bad idea. Will make this improvement as soon as i get some free time! :)