Skadis mini clamp holder
Copyright Claim
Skadis mini clamp holder
Boost
41
96
16
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
43 min
1 plate
0.2mm layer, 2 walls, 15% infill
37 min
1 plate
Open in Bambu Studio
Boost
41
96
16
0
98
68
Released
Description
Englisch:
I designed a simple holder for the Skadis wall from Ikea. This allows you to hold at least 4 small clamps.
Deutsch:
Habe hier einen einfachen Halter für die Skadis Wand von Ikea konstruiert. Damit kann man mindestens 4 kleine Zwingen aufnehmen.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
clean print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect fit, simple solution.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
My adaptation of mini clamp holder. Easy to print.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👌🏽👌🏽
0
Reply
Funktioniert gut
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy print in ABS- thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
The designer has replied
0
Reply
Welche Problem? Was hängst du da für Klemmen ran?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld