Spool Weight for AMS
Copyright Claim
Spool Weight for AMS
Boost
91
187
59
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
91
187
59
4
451
342
Released
Description
This is a Spool Weight for AMS for spool with a center hole of 53.5mm and more.
It's designed for Bambu Spool Reusable and work with many others like eSun (plastic), Duramic 3D cardboard, Eryone cardboard…
I fill the spool weight with aquarium gravel, but you can use other material.
Comment & Rating (59)
All
Thanks for this great AMS weight spool
The designer has replied
1
Reply
Thank you. Your print look very good.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect for what I needed. I had some backstock of stainless steel chain rings that have no project that I could fill them with. For some of my spools they would be too small so I whipped up a quick adaptor plate so I could make them work for anything.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great. Fits inside Bambi spool perfectly to hold one of these (https://a.co/d/0YhEjTF) for when the filament is running low! Thanks again!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great design. I am going to remix the screw on top by cutting out underneath the lid to provide room for a D size battery to fit within the hollowed out area. Finally find a use for a pair of weak flashlight batteries.
Edit to show the re-mixed lid. Middle pic shows original lid on the bottom and the new altered lid on top. Third pic shows a D cell battery just fitting. Adds quite a bit of weight.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
used bearings inside and works great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt perfekt.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked so go the first time, I printed 2 more for stand by. it does stick out on the smaller rolls, however it fits great in the AMS.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
That's what i needed!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great and works just as good.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld