Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 3 walls, 10% infill
Designer
19.4 h
1 plate
Open in Bambu Studio
Boost
149
419
2
3
134
15
Released
Description
Content has been automatically translated.
I wanted a simple small bedside table.
This small side table is simply constructed and has two compartments that serve as storage.
The component must be printed twice and can be rotated 90 degrees in the middle to adjust the look as needed.
You will need 8 round magnets with a diameter of 18mm and a height of 5mm, which you glue into the recesses provided using hot glue or superglue.
The print is very large and time-consuming, so I recommend only trying the print in enclosed printers and deactivating all fans to prevent warping as much as possible.
A clean print bed and application of a layer of bed adhesion should help.
If anyone creates an optimized print profile, I would appreciate it if you posted it online.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)