Search models, users, collections, and posts
Bio
We print, Earth collects: Microplastic - the perfect gift for the next generation!
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Pioneer Maker
Print successful 116 different models and 614 hours
Printed PETG on Bambu A1 Mini and got warping. Please, read more below:
Please NOTE!!! I modified the PETG profile myself — this is not the model author’s fault!!!
Tips to avoid warping (edges lifted from the bed):
I made it with 255°C, try to down to 245-250°.
Clean the build plate.
Bed 70–80 °C.
Low/no fan on first layers.
Slower first layer.
Use a brim.
Color change on layer 3 (as I did) may be too early for PETG: the bottom layers don’t have time to fully stabilize, cool down, and can start lifting. Better to place color change higher, after the base has firmly bonded to the bed. At least at layer 6-8 or better 8-10 color change.
Share
0
0
0
Very nice! Thank you so much. I have now shrimp sushi bar inside:)
Share
0
0
0
No more data