just the wall mount I was looking for, simple yet holds everything in one place, would have been awesome if it had also a charger holder, but no worries I just got a longer cable to charge them up there, I took a risk and mounted it using alien tape(the gel like double sided tape)

came out great, only one leg snapped, but there is nothing a little glue can not solve :))) found it at the right time as my sd cards where always thrown all over my desk risking loosing them

came out really nice, you can see before and after photos that I have attached

quick print, came out really good, printed with PLA and it just does the job that it was made to do

I made the one with no model, the “empty” one, it is really good at holding pen drives

came out really nice, had to improvise a little on the arm/stand/thinghy that holds the hot iron, everything came out as expected, I also had mine laser engraved by a colleague at work (DO NOT LASER ENGRAVE PLA, IT’S MAKING A LOT OF TOXIC FUMES)

nothing bad to say, everything came out as expected and as seen in the photos of the creator! check out how mine printed, amazing!! printed on P1S