xkortanekx

Julia Ebert

Here's one of that start of a whole set of accessories for my Mega Lego-like minifigure.&nbsp;Want to see more like this? <a target="_blank" href="https://makerworld.com/en/u/3138364379/collections/374224" rel="nofollow noopener">Check out all my Mega Lego-like creations.</a>&nbsp;This model is also <a target="_blank" href="https://www.printables.com/model/720392-mega-lego-like-baseball-hat" rel="nofollow noopener">available on Printables</a>.<h4>Printing</h4>This is a much simpler print than the whole minifigure or skeleton: Just print everything in the single included 3MF file. (There are 6 pins in the file, which includes 2 extra in case you lose some or they don't print quite right.) There is support material required for the underside of the hat, which is included in the file. Ideally, this would be printed with tree support, but for now it seems that Bambu Studio freezes and crashes when trying to slice the tree supports for this model (though it does work in Prusa Slicer.)&nbsp;You can print this in PLA or PETG, but I expect that the hat will hold tighter on the head for longer if printed in PETG.If you have trouble with the pins staying adhered to the bed, try adding a brim to them. If they don't quite fit when you assemble the print, try printing them a few percent smaller.<h4>Assembly</h4>User CA glue (cyanoacrylate/super glue) to glue the pins into the ring. Add glue to the top of the ring and pins, then press into place in the top of the hat.

Mega Lego-like Baseball Hat (10:1 scale)

stupid

BrooklynBravest

Magnetic knob that clips onto milwaukee M12 cordless ratchet. Was modeled off of a 3/8" fuel m12 ratchet unknown if other milwaukee ratchets share same dimensions. Allows for easy direction changes especially when wearing gloves. &nbsp;Requires two, 6mm x 3mm neodymium magnets.

M12 Ratchet Direction Knob

tool

STLWarehouse

This is to support a strawberry plant through growth. put each half around the core plant and as the strawberries start to grow they will rest on the support instead of the ground. Keeps a lot of ground-dwelling bugs off of the fruit as well.The model is cut right down the middle, with three supports for each half. This allows you to change the size of the internal hole as the strawberry plant grows. Ensure each half is far enough away from the other during the print that they don't fuse.Recommend printing in PETG to ensure the Sun and UV don't ruin it outside over time. These should last several seasons.&nbsp;

Strawberry Growing Supports

house

dekopuma

Designed for TPU or other flexible filament! The topper grips the top of a can of soda to help seal it off. Convenient tab makes it easy to remove. Cross section view showing how the soda saver grips the rim of the can: <img src="https://makerworld.bblmw.com/makerworld/draft/295621/2023-12-21_bf53e42f7dcd88.jpg">

stupid

tool

house

new