xiaojin84

squinn

A handy tool to help with soldering, de-soldering, or other tasks where you need a steady third hand.  This is a fully printable design, so no other hardware is required.  The clamping mechanism can be adjusted to accommodate boards up to 20 cm in length, and can be installed facing either direction.&nbsp;All STLs are oriented as they should be for optimum printing, which have been designed with the layer lines in mind to result in a strong print (and no supports or brim should be required).

Adjustable PCB Holder Tool

gadget

blecheimer

These are two simple bezels for the Bambu Lab P1P / P1S screen. Choose what you prefer. They will be pressed on the screen from the front and clip to the screen on the backside. Yes, it is a tight fit - if it is too tight for you then you can scale the model with the slicer in z-direction by +0.1 or +0.2% and print again.&nbsp;Disclaimer: This work by blecheimer is licensed under <a target="_blank" href="http://creativecommons.org/licenses/by-nc-sa/4.0/?ref=chooser-v1" rel="nofollow noopener">CC BY-NC-SA 4.0</a> You are not allowed to copy this model to other 3D printing websites without my permission.