Thanks for a very useful model. I was able to correct a layer shift issue on my P1S using these tools. I added 0.6mm to each side and then also used the tools to apply slight diagonal pressure to get the belts to run in the center of the idlers.

Nice print, snaps right in place and redirects the air.

Printed and fit great!

This printed great in PETG (from Printed Solid) on my A1 mini. It fits my U.S.-built 2024 ID.4 although the bottom can move around a little (both positions shown in the pix).

This came off the support very easily. I think the external input could use a locking nut since I have had the PTFE pull out while loading new filament.

Great print profile.

The support came off very cleanly with almost no cleanup. Clever design.

Just what was needed for a new guitar that came with no pick.

Beautiful with natural PLA.

Very fun print.

Easy print with PLA. Great design.