James S

Whopper Printing

NEW print-in-place tracked excavator available on the Etsy link below!Introducing the print-in-place excavator! This is a challenging print if your settings are not refined. Test your overhangs, tolerances, levelling, bridging, and small details.It's best printed WITHOUT support or a brim as parts may fuse together.(The tracked version pictured is on the Etsy link below)I designed this using Fusion 360 and printed this on an Ender 3 V2.&nbsp;If you would like to support me, consider these options:&nbsp;Social Links:<ul><li><a target="_blank" href="https://whopperprinting.com/" rel="nofollow noopener">WhopperPrinting.com</a></li><li><a target="_blank" href="https://patreon.com/whopperprinting" rel="nofollow noopener">Patreon</a></li><li><a target="_blank" href="https://whopperprinting.Etsy.com" rel="nofollow noopener">Etsy</a></li><li><a target="_blank" href="https://instagram.com/whopperprinting" rel="nofollow noopener">Instagram</a></li><li><a target="_blank" href="https://discord.gg/UfyQhUfn4N" rel="nofollow noopener">Discord</a></li><li><a target="_blank" href="https://www.tiktok.com/@whopperprinting" rel="nofollow noopener">TikTok</a></li></ul>

Print-In-Place Excavator

toys

MiscPrinter

Dseing my version of a ¼" chucked mixing paddle. Prints with no support.&nbsp;Spin above 250RPM for optimun mixing. The maximun RPM has not been tested.&nbsp;Good for: paint, epoxy, silicone, water, oil, soap,

Mixing Paddle with 1/4" Chuck

Tools 🔧 

Asphalt3D

Alas, poor Yorick! He hath borne open this drawer a thousand times! Celebrate Hamlet and life's inevitable decay each time you reach for this cabinet knob of Yorick's skull.Designed with a built-in M4 screw/bolt hole. Sample printed on a Prusa Mini at 0.07 mm layer height and 15% infill with Vanilla White PLA. Recommended to print with the flat part of the skull on the print bed. A couple of custom supports under the back teeth will help support the jaw.

toys

Tools 🔧

bits and bobs