printed this out as my tubes kept slipping out of the original hub. this seems to have done the trick and holds them much better than before. going to print out the 5 port one now as I figured it would be nice to have external spool support for TPU.

these seem to have a good amount of torque on the gears. haven’t had any issues yet with slipping or it being too tight.

works great with the BLV 370C kit. is almost a direct fit for it, aside from the kit missing a couple of the screws needed for this version.

printed out perfectly, and rotates around very smoothly. hoping this takes out some of the stress on the tool head pulling the tubes around.

I have printed out quite a few of these at this point, and as usual they work great. they fit perfectly in the 4L cereal boxes and let the filament unroll super smoothly.

Definitely cleans better than a paper towel!

Have one in PLA and one in TPU. TPU is nice as there are no vibration sounds; however, I may remix to print the main basket in PLA and a bushing in TPU to get the best of both worlds.