vulcan.lucky

AJAX3D

This model was created using the original art found here <a target="_blank" href="https://www.thinkfun.com/wp-content/uploads/2014/10/Dragon-Illusion-BBC.pdf" rel="nofollow noopener">Dragon-Illusion-BBC (thinkfun.com)</a>. Once printed, I heated the print along the marked lines with a heat gun that was set to 220c (if printed in anything other than ABS you may need to lower this temp). Once the plastic was soft, I folded the plastic to the correct position (may require some adjusting) I then put a little super glue on the three folded tabs. On it's own, this does not stand up too well. I just placed a little double sided tape under the tail and stuck to the table. You could easily super glue the tail down to a printed platform.&nbsp;FoldingWhere it says "Mountain Fold" this is referring to the side you view the dragon from. See image below to help identify the correct direction of the folds.<img src="https://makerworld.bblmw.com/makerworld/draft/370539/2024-01-06_b15aff33c62e3.png">&nbsp;See the Illusion<ol><li>View from about 2 ft</li><li>Close one eye</li><li>Look into the eyes of the dragon</li><li>Rock back and forth. WOW!</li></ol>&nbsp;Print SettingsPrint at 100% infill with a layer height of 0.04mm with a base layer of 0.16mmFilaments Used: ABS Overture Black Transmission Distance: 0.2 ABS Overture Blue Transmission Distance: 2.4 ABS Overture Light Blue Transmission Distance: 4.8 ABS Overture White Transmission Distance: 4.7Swap Instructions: Start with Black At layer #13 (0.64mm) swap to Blue At layer #20 (0.92mm) swap to Light Blue At layer #32 (1.4mm) swap to White for the rest.

cool stuff