Klexer

Bam!

Works with first layer detectionNo interference with stock plate, I only have one 3rd party plate (IdeaFormer PET Carbon pattern plate) works fine as well.&nbsp;Use PETG ASA ABS to print ( material that can withstand high temp)&nbsp;1.Remove the original wiper2.Cut an A1 silicone wiper in half or 6 rows and install it on top of the new wiper holder3.Remove the purge chute screws4.put the printed part in5.screw the 2 screws back into place6. Make sure the front(the side with silicon wiper) of the printed part sits flat on the front lip of the purge chute&nbsp;&nbsp;I noticed that after printing is completed, the nozzle parked on the right edge of the wiper during filament retracting. You can avoid this by changing one line in the end G code(see picture 3). By doing so nozzle will park a little bit to the right. This is optional use at your own risk.

Bambu P1S