I love the eggs. One thing. The petals bind when printed in silk PLA. You will need to use an Exacto knife to cut the connection points free sort of like small tack welds. After that, rotate the iris closed and use a deburring toll to clean the outside edges of the internal inner ring where the binding takes place.

Very well done. Print the brackets in PETG. Silk PLA is a bit too brittle.

Exactly what I needed.

This printed easily and cleanly without any supports needed.

Perfect for my glasses.

These are fun and really well done.

These work great so far. I needed something that did not take up much space as I already have a camera mounted to the nearby filament cutter peg. Other options would not fit.

This works great. I already had a Blink Mini 2 camera attached to my A1 Mini and wanted to do the same for the A1. This fit the bill perfectly.

This helped a great deal. I have limited space to the right of my printer. Redirecting the cable rearward freed up a few inches.

These are great not only for hanging filament but for easy empty spool and spool adapters as well.

These were just the thing that I needed to clean up my filament rack. Much cleaner than the vacuum sealed spools alone.

This was perfect for my need.

This saved me a bit of time with an installation that I was doing. I shortened the length a bit for my need but that's it.

These were great, all three of them.

This turned out phenomenally well. For my print I modified a standard lamp kit 001 base to fit an E26 smart bulb. This allowed my to use a full sized E26 smart bulb and have all the benefits of that such as more colors and a much brighter light source. I mounted the light to a very short lamp base. It turned out perfectly. Variable colors, variable brightness and voice activation using a smart speaker and the smart bulb.

This printed great and is silky smooth when rolling.

This works great.

This worked great for running a PTFE tube from my dryer to the A1 Mini.

This worked great though I used the mount points a little differently using the PTFE mount to add an articulated light to my A1 Mini.

This worked perfectly.