I technically needed a tray for the smaller stones/beads but think this design is pretty cool. my wife will love it. I did the base in purple up to the lines, and then switched to marble. I like the look. even though it isn't on the list, I printed on an A1 mini and upscaled 130%. looks nice. thank you for sharing.

this is pretty a good design. I am new to this so enjoying how these designs come together. I do wonder if the height of the base could be cut in half. not sure if it is possible before the print to shorten the models. thanks for the setup.

pretty easy print and build. I ran a second print because half of the smaller handle either did not print, or slid off and I couldn't find it. 2nd run was just fine. easy gluing together. thank you.