These are fantastic to give to the kids at Halloween. Thank you

Totally stunning, thank you, so happy with this as I love my wolves. It is difficult to do that 5th colour with an AMS but I managed, so feeling a little chuffed with myself 😁Printed on Bambu A1. I really like how slow it printed this was obvious on the black layer as it was totally smooth. I'll add some pictures of the print journey as well as the finished print. I used this frame https://makerworld.com/en/models/709013-slim-square-friction-fit-frame#profileId-639290 A totally deserved boost to you 😊 I just looked at your other prints OMG, so excited, you are very talented 😍

This was my first Hueforge. I used your colour scheme as this was a gift for a new baby girl. I love the Voxelab Abyssal Red! I noticed that the right side, top & bottom corner started to lift. In future I will add glue to these areas when I do a print. Lovely design, thank you!

I liked this design but very disappointed in this print. Printed with a Bambu A1, silk filament. Too many lines showing, not good enough quality to give as a present. As you can see the face that was on the print plate looks better but that's not the look I was going for with a silk filament. If you know how I can improve this, please advise.

Roman Helmet very nice. Printed with no issues using PLA Marble. Currently printing some in a tri silk PLA. I managed to break a couple of side pieces of the helmet when removing trees. I'm guessing the silk is a little more fragile than the marble PLA

I printed this at 50% using PLA Marble. Printed beautifully! My daughter is miniature obsessed and loves it...

Prints really well. It is tricky to operate if you have not done it before. Because we did it as a gift for a grandchild we did mark in a cheat with pen. She loved it...

Daughter printed this for me for Mother's Day, and I love it. The supports were difficult to get out. The purple layer matched my decor better we used glow in the dark for the mother & child layer. Must have taken some time to design, very well done!

These flowers are lovely and deserve the 5* however the stems are not, and I would rate at 2* We fiddled with the stems, rotated to print standing using a brim and no supports. So that there were no supports we had to shave off one of the little leaves. As you can see the I do love the flowers. I used the poop in the vase to keep the stems stable.

A gift for my Mum, still to add the succulent. She will love it. I still use the Bambu Lab settings, and this is one of the best prints I have done for quality. The surface is smooth especially the top surface layers. The Buddha pic is to demonstrate what I mean. I wonder if this is because it's flat and square, not rounded. Fitting everything was tight and I had to sand the inserts down so they would fit in the holes. The upside to this is that they will never fall out. Thank you, great print!

Love this, was a great way to give the Grandkids cash for their birthday. The Australian $ was a bit longer so had to fold an end. For the next one I might try and lengthen it. Hopefully that does not mess up the picture.

Travel Tag for suitcase, we like it

Lovely print, came up well in glow in the dark