simple print. only holds two dentek flossers but is very compact and lightweight to carry around

printed first with inland ABS because of the temperature concern. had to change a ton of settings because inland brand doesn’t like the same default settings as Bambu labs slicer's generic ABS. still got a little warping at the edges, but more importantly the yeti bottle didn’t fit. the ABS shrinkage was just enough that it became too small. perfect for other, smaller bottles though. so I tried again with Bambu PETG translucent (because that was the only purple PETG I had) and didn’t change any settings. no warping and the yeti bottles fit perfectly. my husband thinks they are too snug to grab while driving but we haven’t road tested them yet.

came out great! thanks!

came out great! thanks!

cool! had a little trouble with some of the letters not being as clean as I would have liked. I specifically used same brand PLA basic in hopes of avoiding issues with the transition from basic to silk for the gold. also got this strange band in the layers with the letters. maybe I needed to up the purge settings.

cool! thanks!

scaled way down and printed a small army! they look great! thanks!

love these! added a name and printed a bunch for a cousin’s baby’s baptism.

shrunk him down about 50%. super cute!

scaled way down to be 30mm. came out well.

very cool! thanks!

came out great. go slow removing supports.

came out great! feels great also! thank you! added some flushie fidgets to combat the poop

came out perfect! love it! thank you!

came out great! thanks!

fun! my only complaint is the four white tabs, for lack of a better descriptor, that appear on the edges. not sure why they are there. I shaved them and they’re not as pronounced but still evident

looks pretty cool. some areas could be smoother and the bottom supports were a real pain to remove. I’d probably try increasing the Z top for supports even higher than .25 if I print again. thanks for the cool design.

spins well! I modified to Z top on the supports to .25 and they came right off. thanks!

they look great! thank you!