user_697061905

Celestin

Here is a tic tac toe for travel, small and ultra transportable, it can fit in your pockets and it is easy to print. You will just need support for the lid closing system.You will need to print:<ul><li>*1 the box</li><li>*1 the lid</li></ul>*6 the circles and crosses.You also need 2 magnets of 6mm by 3mm in height to make the cover fixing system.Good games to you and have fun!

Tic Tac Toe travel 

Games

Jonas Daehnert

<h3>A really loud, flat whistle that you can comfortably carry in your wallet.</h3>About the Whistle:With a thickness of only 3 mm, the flat whistle fits in any wallet. Despite its flat design, it&#39;s really loud. It is also possible to wear the whistle as a chain or attach it to a keychain.&nbsp;Sound:It has a clear double tone. Due to the size, the sound is quite high. But it is enough to get attention. &nbsp;Dimensions:43 x 22 x 3 mm (additional variants 43 x 22 x 4 mm - 43 x 22 x 5 mm - 39 x 11.5 x 3 mm)&nbsp;How to Print:I recommend using a nozzle size of 0.4 mm and a layer height of 0.2 mm. Don&#39;t use supports. It&#39;s very important that the first layer is perfect, because the wall thickness at the top and bottom is only 0.6 mm. If your printer is well leveled, however, there should be no problems.&nbsp;Troubleshooting:If your whistle doesn&#39;t work properly or you have problems printing a smooth top surface, make sure the <a target="_blank" href="https://help.prusa3d.com/article/layers-and-perimeters_1748#layer-height" rel="nofollow noopener">layer height</a> is set to 0.2 mm. This ensures that the bottom and top surfaces are printed at the correct thickness. You can also experiment with the <a target="_blank" href="https://help.prusa3d.com/article/layers-and-perimeters_1748#perimeters" rel="nofollow noopener">perimeter value</a> if there are problems with bridging. Any value between 2 - 3 is recommended. And last but not least, the <a target="_blank" href="https://help.prusa3d.com/article/layers-and-perimeters_1748#solid-layers-top-bottom" rel="nofollow noopener">solid top/bottom layer</a> should be set to at minimum 5 each.&nbsp;Print time:~ 10 - 20 min (depending on your settings)&nbsp;Happy whistling!&nbsp;&nbsp;&nbsp;

Games

Fun Prints