This thing printed without any issues (from design or setting at least). The attention to details! I had an "exploded" refill roll which got loose from its holder. So I tried this and it saved it! What a gem! If I had to comment on something it would be the lack of a simple assembly manual. There are lots of details in the updates and comments but not everyone (me :) ) reads those at first. Most of the assembly I could figure out. But the pin steering and the tube needed some more attention (sanding and greasing). Also a later discovery was that the cogs and bearings needed to be freed, the internal rings where printed stuck. I had them "rolling" on the pins. Some came loose by just pressing them. I couldn't get the double cog freed. The bearing grease holes (again awesome details) needed to be placed the right way (holes on the outside) otherwise you can't reach them. I also printed the "spool donor roller" kit and it fitted great together. What a great project. Boost well deserved.

Printed great, used petg. Thx!

Fun little print. 1st print by app failed changed profile to default 0.16 high, lowered 1st layer speed to 30, outer wall to 50 and scaled it down to 100%.This gave the results on the photos Thanks for sharing.

Beautiful design printed without any problems, thx!