saw this model up had petg and pla in the ams so i hit print , worked out the first try (thankfully) then after swapping the pla to a matte red i tried again and the petg just would not stick to supports , no fault to the profile i assume its just something with the bambu matte pla

took a bit to get it to stop binding , i actually ended up putting some rc car dif lube in it but the discs really fly

holds 2 full sets of drift wheels prints fast and easy

i reprinted the frame with an extra wall because i broke it the first time worked flawlessly after that

nice easy print

turned out great , mom seen these on Tik tok and had to have one so here I am

works

clean

clean

lid snaps tight

clean

solid

clean

prints nice

clicked right in

little tight but that could be something on my end , turns nice after working it a bit

good print