Easy print if the printer is well tuned: I didn’t want to reorient for quality reasons (scars) so… I put a Support Block on the dome and it printed very fine in the original orientation saving a lot of filament

simple, efficient

good print, just the tote could probably be improved

Nice design, clean

It printed easily and beautifully, I made a few of them as gifts Thankyou very much!

Lovely rendition, few supports were mildly annoying

really clean print at 0.16 with bamboo silk metal

Very easy and beautiful print, thanks for sharing it

very cute print, it will make a perfect gift for someone who loves Dachshund dogs. This was the fuzzy version.

The miniature is very good and it printed magnificently. Supports were difficult though and the smoke broke off (solved with rapid glue)

Printed 4 more at 100% amazing. While the supports might be a bit more annoying i suggest to print the teeth vertically: it improves their quality dramatically (p1s 0.16mm layers)

printed beautifully even on 0.4 nozzle

wonderful print, done it 150% and handcolored with a friend for a gift (thankfully she can paint)

supporta are quite a pain, but it came out very good