user_4240690641

KobaRiley

<h2>Cable Tidy for Bambu X & P Series</h2>Got a bit tired of the messy setup on the back of the printer, and designed some cable supports that don't need screws or magnets.Also got a bit carried away and designed a few different versions.&nbsp;The PTFE tube on the right side, that goes to the printer, is free to move back and forth, but stays in the channel.The cables and tubes keep everything in place, but I've added some double sided tape on mine to keep it a bit tidier.<h3>Install</h3>To install the plate, you need to remove the two cables, and the left hand side PTFE tube. Then, remove the PTFE tube at the connector closest to the printer… feed that tube through the hole in the cable tidy plate, and then just reconnect everything.&nbsp;I've had this running on two printers for about 20 prints each, and have had no issues.&nbsp;There are different designs available, from 4, 3, 2 and 1 colour. The 1 colour basic version is by far the fastest to print… The Texas version is my favourite, and looks much better in reality than my awful photos….&nbsp;<img src="https://makerworld.bblmw.com/makerworld/draft/601192/2024-01-16_432ca9585a8cb.jpg">&nbsp;&nbsp;The cables and tubes can still be removed with the standard little tools that are everywhere on Makerworld, but I've included a couple that fit slightly better with with this plate.<figure class="image"><img src="https://makerworld.bblmw.com/makerworld/draft/601192/2024-01-16_6a6ab2a212209.png"></figure>&nbsp;This project took several days, and many many test prints. If you like the model, and feel like buying me a coffee, it would be greatly appreciated. <a target="_blank" href="https://ko-fi.com/kobariley" rel="nofollow noopener">https://ko-fi.com/kobariley</a>&nbsp;

Cable Tidy - X1- P1S - P1P

十二月

0.1.1版本更新，已对红色圆盘拆分。&nbsp;0.1.0萌新首个作品，从23年11月刚开始接触3d打印机，在双11购入p1s后逐渐学习相关知识，正逢龙年春节到来之际，制作了自己的首个模型与大家分享。本模型默认为百分之150放大，（新年快乐红色底盘部分除外，红色地盘分件缩放比例为百分之80，请各位打印时注意调整缩放比例）诸位可根据实际情况进行修改。由于本人能力不足，红色圆盘部分未进行切分，请各位自行分割打印，或缩小打印。<img src="https://makerworld.bblmw.com/makerworld/draft/419877/2024-01-18_fa25233ec4049.png">此部分为80%缩放比例，请各位打印时注意调整缩放比例。